QLOCKTWO MOON Gebrauchsanleitung Seite 43

MOON 90 – mounting the wall bracket
1. Check the load-bearing capacity of the dowel connections and the wall.
2. Set the position of the MOON 90.
3. Mark the drill holes using the mounting template.
4. Hold the wall bracket against the wall in the desired position and align horizontally.
5. Before drilling, check the wall for pipes and cables (electricity, water, etc.).
6. Drill the holes in the correct size (see mounting template), clean, and install the corresponding connectors
(e.g. dowels). Use the screws supplied to affix the wall bracket to the wall (see Fig.
MOON 90 – mounting
Mount MOON 90 onto the wall bracket from above using the opening in the back designed for this purpose.
MOON 90 is installed correctly when the back is flush with the wall and rests securely on the wall bracket.
MOON 180 – mounting the wall brackets
1. Check the load-bearing capacity of the dowel connections and the wall.
2. Set the position of the MOON 180.
3. Hold both wall brackets against the wall in the intended position and align vertically.
4. Mark the drill holes.
5. Before drilling, check the wall for pipes and cables (electricity, water, etc.).
6. Drill the holes in the correct size (see mounting template), clean, and install the corresponding connectors
(e.g. dowels). Use the screws supplied to affix the wall brackets to the wall (see Fig.
MOON 180 – mounting
Mount MOON 180 onto the wall brackets from above using the openings in the back designed for this purpose.
MOON 180 is installed correctly when the back is flush with the wall and rests securely on the wall brackets.
2. ).
4.
).
EN
EN
5 43