Milnor Linear Costa Betriebsanleitung Seite 8

The machine's normal operating mode is fully automatic. After the machine is set for automatic
operation, a new load and its batch codes passes from the loading device to the machine each time a
loading device discharges. Then the machine stores the batch and waits for a signal to transfer the batch
or receive another batch from the loading device.
Comply with all safety instructions in this manual and on this machine.
Switch Symbol Selection
signal sounds and a series of displays appear.
G1B>9>7*6Q\\ 5^dQ^W\U Q^TCdbY[U8QjQbTc
<PRWX]T\^cX^]RP]RPdbTh^dc^UP[[^aQTR^\TT]cP]V[TSX]^abcadRZQh]TPaQh
^QYTRcb XU h^d bcP]S fP[Z ^a aXST ^] cWT \PRWX]T  BWdcc[Tb P]S R^]eTh^a QT[cb
\^eTPdc^\PcXRP[[h
:TT_h^dabT[UP]S^cWTab^UU^U\PRWX]T
and silence the operator signal.
Displays indicate machine action and will prompt for cake data for any position where the
machine detects a load during initialization.
Switch Setting by Name/Function
Set the Run/Program keyswitch to run.
Ends the series of displays.
Press the Start button (
Press , to answer no and prompt for next question. Press
to answer yes and enter cake data. See "Enter Cake Data" in this
section.
The machine is ready for automatic operation.
4
Set the Master switch to on (
) to initialize for automatic operation
<B>DB;=>04 (#""0E
). The operator
,