Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Switching off
1. Press the On/Off button (11).
The light (2) goes out.
2. Press the On/Off button (11)
again.
The device switches off com-
pletely.
Changing the lighting mode
Press the Level button (12) repeatedly
until the desired light level is activ-
ated.
The light level indicator (10) shows
the set light level.
Light
Mode / Light output
levels
1
Permanent light - 1000 lm
2
Permanent light - 5000 lm
3
Permanent light - 10000 lm
/
Flashing mode
Pairing the LED floodlight
Notes
• The pairing function works per-
fectly up to a distance of 20 m
(without barriers).
Connecting the LED floodlight
1. Switch on the device.
2. Press the RF button (13). The SYN
indicator (14) flashes.
3. Repeat steps 1-2 for all LED flood-
lights you want to connect.
4. Press and hold the RF button
(13) for about 5 seconds on each
device to be connected. The SYN
indicator (14) flashes at a fast fre-
quency.
5. Press the RF button (13) on each
device again to confirm the con-
nection. The SYN indicator (14)
now lights up permanently.
Disconnecting
1. Press and hold the Level button
(12) and RF button (13) simultan-
eously for about 5 seconds on
each device you want to discon-
nect. These connections will be
disconnected.
PARKSIDE app
The PARKSIDE app lets you monitor
the device and control certain func-
tions. The functions may change with
updates to the app and firmware. For
more information on the PARKSIDE
app, see the instructions for the smart
battery.
Requirements
To find the device in the PARKSIDE
app, the following requirements must
be met:
• The PARKSIDE app is installed on
your smartphone and Bluetooth®
is activated.
• The following battery is inside the
device: PARKSIDE Performance
Smart battery PAPS 204 A1
or PAPS 208 A1. This battery
is already connected to the
PARKSIDE app.
The device communicates with the
app via the battery.
Connecting the device to the
PARKSIDE app
1. Insert the smart battery (20).
2. Press the On/Off button (11).
The "Connected" display (8)
flashes three times. When the
device is connected, the "Connec-
ted" indicator lights up continu-
ously.
3. Open the PARKSIDE app.
4.
Your tools.
The device is displayed in the list.
If the device does not appear in
the list, add the device manually.
GB
MT
23
Werbung
