Beatbot AquaSense Kurzanleitung Seite 3

After powering on, press the "Power" and "Quick Mode" buttons simultaneously for about 3s, and when you see the indicator
ashing blue, the robot is ready for network setup. Then, choose either of the following methods to complete the connection:
A
Preparation Before Use
Charging
1
Install the charge dock
Before Cleaning
Before entering the water, it is crucial to place the robot on a level ground and to wait for about 5s for
it to calibrate. By following these steps, you ensure maximize the effectiveness of the robot's cleaning
path. The robotic pool cleaner will automatically disconnect from the phone after entering the water.
1
Ensure the robot has
su cient power (the
indicator shows solid
green).
After the cleaning task is completed, the robot will automatically dock on the surface next to the wall. If the robot is pulled out with a hook
during cleaning and does not have enough time to drain, it may not be able to surface automatically as intended. Please continue to let the
robot drain for 2-3 minutes.
Tips
If this is your rst time using the pool this season, we recommend that you clean it manually rst by removing any large debris. After
that, you can use the robotic pool cleaner to maintain the cleanliness. This is because if there's a lot of debris left in the pool during
the o -season, using the robot will cause the lter basket to clog more quickly and require more frequent cleaning. Therefore, it's
more convenient to start with manual cleaning.
Each machine undergoes thorough testing, including underwater testing, before leaving the factory. As a result, there may be
some residual water stains, which is normal. Please feel free to use it.
2
Plug into the power supply
2
Set the cleaning mode, and
the selected mode button
will show solid white.
B
OR
3
Place the robot
3
5s
Place the robot on a
level ground and wait
for about 5s for it to
calibrate.
4
Charging
4
Place the robot in the
water to start
automatic cleaning.
EN
2