Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Emergency lowering feature
The frame-integrated drive technology ensures high
security as cables, fittings and motors are totally
enclosed for minimising the risk of injury. The frame
is lowered only by its own weight. Therefore only the
weight of the corresponding section of the deck area
presses on the stuck body part. Injuries and bruises
are almost excluded.
In case of power
failure the frame can
be quickly lowered by
hand without tools and
batteries.
Operating the handset
lower the leg adjustment motor. (S5) and (S6) move
the back and leg adjustment motors simultaneously.
Only with radio remote control: Press (S5) and (S6)
simultaneously for night light / underbed lighting.
Materials
Polymers
We exclusively utilize thermoplastic and thermoelastic
polymers that may be completely recycled after their
use. Markings on the individual parts enable the
proper sorting and recycling of the plastics involved.
All plastics are dyed and not painted or lacquered.
Softening agents and other damaging additives are
not used.
Wood
Wood frames and slats are constructed of laminated
wood. The laminating process uses special resins
that are physiologically unobjectionable. Frames and
slats are, according to style, laminated multiple times,
feature low formaldehyde content in accordance with
European standards, and assure maximum elasticity
over time.
The buttons of the handset
control the positioning of your
bed.
(S1) and (S2) raise and lower
the back adjustment motor,
(S3) and (S4) raise and
Care instructions
This product must be protected from extended
exposure to sunlight. Clean only with pure water or
mild soap. Do not use detergents, abrasives, alcohol,
acetone, or similarly aggressive cleaners. The warranty
for damages caused by using unauthorized cleaners or
cleaning methods cannot be honoured.
Decommissioning and disposal
Warning – Danger of injury by getting trapped!
It is necessary to drive the bed
frame into the basic position
before dismounting.
-
Disconnect the mains plug
-
Remove the power supply
unit and remote control from
the motor
-
Loosen the motor screws
-
Now you can use the remaining
electronic components dispose
separately (e.g. hand
switch, Control unit,
power supply unit
and accessories).
Decommissioning
This product must not be disposed with
domestic waste!
-
This product contains electronic
components, cables, metals and synthetic
materials. It must not be disposed with domestic
waste. This product must be disposed of in
accordance with the current disposal regulations of
your area/country/state as electronic waste.
-
The 9V and AA batteries (both alkaline-manganese/
alkaline) that may be included must be disposed
of in accordance with the Battery Act (BattG).
Make sure that the batteries are completely empty.
Remove the batteries carefully, observe the further
explanations in the relevant operating instructions
and dispose of the batteries and the unit separately.
-
This product is not subject to the EU directive
2012/19/EU (WEEE).
Special designs available on request.
Subject to technical alterations.
13
Werbung
