Instructions for Use and Care
12
Bed system, low profile frame with dual motors
Thank You
You have chosen a pressure relieving low profile bed
frame. This product was manufactured according to
our strict quality standards. Should you, despite proper
assembly and use, have any reason for complaint,
please contact your authorized dealer.
Safety warning
The Bed Bases meet requirements
and specifications of DIN EN
1725. As specified the bed system
should be used as a foundation
in conjunction with a standard
mattress.
With normal use (lying, sleeping,
sitting) a maximum strain of 120
kg over the entire bed surface is
possible without any restriction.
Please note that the manufacturer
cannot take any responsibility for incorrect use and
capacity overload.
Please note the following items:
-
Verify the secure positioning of the bed system
within the frame.
-
The low profile frame must be placed on a level
base to prevent any deformation of the mounting
hardware.
-
Hardware may suffer damage as a result of
excessive weight or force to concentrated areas of
the inner slat frame, such as sitting on the raised
head or foot sections, for example.
-
While adjusting the bed frame, assure that no body
parts (including those of third persons) can reach
between the moving parts. Prohibit children from
operating the bed adjustment feature! Otherwise
there is a risk of crushing injury.
-
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they
do not play with the appliance.
-
The mechanical parts, as well as the motors, must
be able to perform their operations unencumbered
and unrestrained.
-
During operation, ensure that no third persons (for
example children, or even pets) are present in the
area of the adjustment mechanisms.
-
If the mains lead of this appliance is damaged, it
must be replaced by the manufacturer or its after-
sales service or a similarly qualified person in order
to avoid hazards.
120 kg
Installation instructions
During assembly of your bed frame it is important to
make certain that a minimum of 6 connection points
guarantee secure support.
-
All cable ties must be removed from adjustable
frames before operation can begin. Prior to initial
use please assure diligently that all cable ties have
been removed, otherwise damage to the motors or
frame may result.
-
This product was manufactured according to DIN
EN 1725 (Beds and mattresses: Technical safety
requirements and testing procedures).
Mattress holder
Mattress holders are
necessary to avoid sliding of
the mattress. The mattress
holders are optionally
available.
Motorised Frame
Please abide by the information on the control
switch and any additional instructions in the
respective operating manuals.
2-motor drive
The motorised frame uses a dual motor drive for
continuously variable adjustment. Head and foot
section are separately adjustable.