Object Types; Elements Of The Active Route - Audio Vox iGO primo Bedienungsanleitung

2.3.3.5 3D object types
Your software supports the following 3D object types:
Type
3D terrain 3D terrain map data shows changes in terrain, elevations or depressions
in the land when you view the map in 2D, and use it to plot the route map
in
3D when you navigate. Hills and mountains are shown in the background
of the 3D map, and illustrated by colour and shading on the 2D map.
Elevated roads Complex intersections and vertically isolated roads (such as overpasses
or bridges) are displayed in 3D.
3D landmarks Landmarks are 3D artistic or block representations of prominent or
well- known objects.

2.3.3.6 Elements of the active route

Your software shows the route in the following way:
Symbol
Current GPS position and
Start point
Waypoint (intermedi-
ate destination)
Destination (end point)
Route colour
Descrip-
tion
Descrip-
tion
Your current position displayed on the map.
In pedestrian mode it is the exact GPS
•
position.
If a vehicle is selected for route calcula-
•
tion and roads are near, the symbol is
snapped onto the nearest road.
Normally if GPS position is available, the route
starts from the current position. If there is no
valid GPS position, your software uses the last
known position as the start point.
An intermediate destination of the route be-
fore reaching the final destination.
The final destination of the route.
The route always stands out with its colour
on the map, both in daytime and in night colour
mode.
20