Werbung
Verfügbare Sprachen
Verfügbare Sprachen
C300-Feeder-lnstructions-07-2021
36606
0721
-
IMPORTANT
INSTRUCTIONS
• Read all instructions
product.
• Register your purchase on-line at www.closerpets.com
(see guarantee)
• Do not allow children to play with this product.
• Inspect product regularly
damage. Do not use if in doubt.
• This product is designed
described
in these
instructions.
• Dispose of all packaging material properly.
NOTE: Plastic bags could cause suffocation - keep
away from children and animals.
SAVE
THESE
1. Battery installation
/ bowl alignment
1.1 Remove feeder lid by pressing down lid and pushing in
the sprung clips on both sides (Fig. 3) Lift the food bowl
off the feeder base and remove the battery cover by
releasing the retaining clip (Fig. 4)
1.2 Insert 3 x AA batteries
marked on the inside of the compartment.
battery cover.
After a short period of self testing, the clock (O, Fig. 2)
will show 12:00 AM outlined by a highlight frame with two
feeding time indicators ( (b) and @ , Fig. 2), showing
:
— beneath.
Temporarily replace the food bowl and lid If the lid and bowl
are not correctly aligned, remove lid then press ADJ/SET
and UP buttons together to 3 seconds to achieve alignment.
Good quality alkaline
approximately
12 months (dependent on use). You may use
all popular batteries including rechargeable
batteries but the low battery indicator will only work correct y
with
standard
alkaline
batteries.
2. Setting the clock
NOTE: To change clock between
(AM/PM)
formats,
press
together
with the DOWN arrow
changes.
If at any point during setting a button is not pressed within
30 seconds, all digits will stop flashing and any adjustments
made will revert to default/previous settings.
2.1 If necessary, move the highlight frame to outline the
clock display
using the UP or DOWN arrow buttons.
To set the clock, press and hold the ADJ/SET button for
5 seconds until the hour figure starts to flash Press the
UP or DOWN arrow buttons to adjust the clock to the
correct
hour.
2.2 Press the ADJISET button and the minute figure will
flash. Adjust
using the UP or DOWN arrow buttons.
Press ADJ/SET to save the setting
3. Meal time setting
The C300 feeder will automatically
time(s) every day once you have set the required
.qxp Finished size A5 210x148mm 30/07/2021
SAFETY
before installing
or using this
for correct operation
and
for use with pets only, as
INSTRUCTIONS
using the orientation
symbols
Replace the
batteries
should normally
and 1.5v lithium
24 hour and 12 hour
and hold
the ADJ/SET
button
button
until the format
serve meals at the same
meal
times. For example, if you require one meal a day you need
only set the time for MEAL 1 to allow feeding up to 2 days.
If you require 2 meals in a day you will need to set the times
of MEAL
1 and MEAL
2
Set your pet's required daily meal times as follows:
NOTE: Meal times will automatically
order (earliest to latest time) on the display. The next meal
will be served at the next programmed
For example (see Fig. 5), the current time is 15:00, so the
next
meal
will be served
3.1
Press
the
UP or DOWN
highlight frame to MEAL 1. Press and hold the ADJ/SET
button
for
3 seconds
flash. Set the hours for MEAL 1 using the UP or DOWN
arrow buttons. Press ADJ/SET to save setting
3.2 The minute figure will flash. Adjust
DOWN arrow buttons. Press ADJ/SET to save setting
NOTE: Meal
times
increments.
Repeat 3.1 and 3.2 for MEAL 2 if required
3.3 To cancel a meal time setting use the UP or DOWN
arrow buttons to highlight frame the relevant meal time.
Press
and
hold the ADJ/SET
flashes. Then press the UP and DOWN arrow buttons
together
until
the
shows
4. Testing your C300 feeder
Your C300 feeder is manufactured from top quality materials
and is assembled to comply with rigorous quality standards
Consequently,
it should give you many years dependable
use
However,
we recommend
operation
with your cat(s) while you are in attendance
completing
set up as follows:
4.1
Fill the required number of bowls, starting clockwise
from 'I'
(only fill bowl 'O' if an immediate
ast
required).
Take care not to overfill the food bowls in
order that the rotating lid is not fou ed
4.2
Insert
pre-frozen
aligning 'O' on food bowl (Bl , Fig. 1) with 'O'on base unit
(D1, Fig. 1). (If the 'O' on the food bowl does not align
with the 'O' on the base unit, press the ADJ/SET and UP
arrow
buttons
together
alignment.)
4.3
Finally, replace feeder lid ensuring the sprung clips on
each side click into position and place unit in required
position.
The meal in the bowl numbered
served at the next programmed
4.4
Always turn feeder off after use (see Section 9 below)
5. Especially
for cats
When leaving your cat, do not forget to make adequate toilet
arrangements
for it. Cats and particularly kittens, should not
be left alone for long periods without someone
periodically
that all is well. We also recommend the use of
a Cat Mate fountain for supply of fresh water.
6. Especially for dogs
Most small dogs will readily adapt to an automatic feeder,
but you are recommended
encounters
to ensure that it is unlikely to damage the unit
- which may be a problem with puppies
4
10:07 Page 4
sort into chronological
meal time.
at
17:00.
arrow
buttons
to move
until
the
MEAL
1 hours
starts
using the UP or
can only be set in 10 minute
button
until
meal
time
disappears
and
display
you ensure
its correct
meal is
ice pack
and
replace
food
for 3 seconds
to achieve
'1' will be
meal time.
to check
to supervise your dog's first few
the
to
time
by
bowl
Werbung
