cecotec CONGA CARPET&SPOT CLEAN INFINITY Bedienungsanleitung Seite 33

ENGLISH
tank; if you continue using the tank after the wastewater has exceeded the maximum
water level, the float valve will automatically stop the machine vacuuming water.
Cleaning the clean-water tank
1. Remove the clean-water tank in the arrow direction, as shown in the assembly section.
2. Loosen the cap and empty the remaining water.
3. Tighten the cap of the clean water tank again and install the empty tank.
4. Press the power button to turn on the device.
5. Press the water release button to empty the remaining water in the device.
Cleaning the suction nozzle
1. Press the suction nozzle release button and separate it from the hose bracket. Fig. 20
2. Remove the front cover by lifting it with your finger. Fig. 21
3. Rinse the suction nozzle and the cover. Fig. 22
4. Install the suction nozzle cover again. Make sure the pins are correctly placed in the holes
and press these parts until they click. Fig. 23
Charge the appliance
Connect the charger to the device as shown in figure 24.
6. TROUBLESHOOTING
If you observe any problem, carefully read this manual and try any possible solutions before
contacting Cecotec Technical Support Service.
Problem Possible causes
The appliance does not work, Battery is discharged.
and the switch is on
The internal line or power
cord are broken.
When pressing the water The nozzle is clogged.
release button, there is no
water or little water released
The bracket or pump are
damaged.
64
CONGA CARPET&SPOT CLEAN INFINITY
Possible solutions
Reconnect to the power
supply
Contact the official Cecotec
Technical Support Service.
Remove the suction nozzle
and clean it with clean
water.
Contact the official Cecotec
Technical Support Service.
It does not vacuum, or it is The power button is in the
too weak Off position.
The waste-water tank is
full, which activates the
buoy.
The hose does not work
properly.
The waste-water tank is
not correctly installed.
If after these tasks the problem still occurs, contact the provider or the official Cecotec
Technical Support Service.
Warning
Do not try to disassemble, repair, or modify the device by yourself.
7. TECHNICAL SPECIFICATIONS
Product: Conga Carpet&Spot Clean Infinity
Product reference: 08666
Voltage: 100-240 V ~, 50/60Hz, 0.4 A
Power: 150 W
Battery:
18.5 V ⎓, 2200 mAh, 40.7 Wh
Type: 5INR19/66
Technical specifications may change without prior notification to improve product quality.
Made in China | Designed in Spain
8. DISPOSAL OF OLD ELECTRICAL AND ELECTRONIC APPLIANCES
This symbol indicates that, according to the applicable regulations, the
product and/or batteries must be disposed of separately from household
waste. When this product reaches the end of its shelf life, you should dispose
of the cells/batteries/accumulators and take them to a collection point
designated by the local authorities.
Consumers must contact their local authorities or retailer for information
concerning the correct disposal of
ENGLISH
Turn on the power button.
Empty the waste-water tank
and use it again.
Check the hose is not
cracked, broken, or clogged.
Install the waste-water tank
correctly.
65
CONGA CARPET&SPOT CLEAN INFINITY