Before Operation - Mitsubishi Electric ecodan PAR-WT50R-E Bedienungsanleitung

4

Before Operation

Remove the battery case cover before plac-
ing the wireless remote controller, and place
two AA alkaline batteries properly.
* When the wireless remote controller is not
paired, it has to go through a pairing process.
For details about pairing, contact your service
contractor.
■ Batteries
● When is shown on the display, the
batteries are running out. Replace both of
them with two new AA alkaline batteries.
● Do not use Ni-Cd rechargeable batteries.
● The AA alkaline batteries used on the
wireless remote controller last for about 1
year under normal usage.
● When not using the wireless remote
controller for long periods of time, have
the batteries removed.
Caution
Always place batteries with correct po-
larities as indicated in the battery case.
■ Installation
The wireless remote controller has two meth-
ods of installation, using an included bracket
or stand.
<< Using a bracket >>
Determine the position to install the wire-
less remote controller.
Fix the bracket with flat head screws.
Mount the wireless remote controller onto
the bracket.
Note)
● Avoid over-tightening the screws, which may break or deform the bracket.
● To enhance stability, use all the four screws to secure the bracket.
5