Silvercrest STLK 8 D2 Bedienungsanleitung Und Sicherheitshinweise Seite 44

SilverCrest STLK 8 D2
10.5 Reassembling the air cooler
Once you have carefully cleaned all parts of the air filter, you can reassemble it. The procedure is as
follows:
If you wish to continue using the air cooler, fill the water reservoir
1.
(13).
Insert the air filter (11) into the water reservoir (13), push both
2.
back into the housing (12) and replace the front panel (10) so that
the closure flap on the front panel (1) clicks into place. To do this,
feed the lug on the bottom of the front panel with adjustable air
outlet grille (10) into the recess in the bottom of the front side of the
casing then push the top edge of the front panel with adjustable air
outlet grill (10) against the housing (12) until the closure slot on the
front panel (1) clicks into place.
If you wish to continue using the air cooler, reconnect the power
3.
supply.
11. Transporting the air cooler
If you wish to transport the air cooler, disconnect it from the mains power and disconnect the power
adapter and the power adapter cable from the device. Always carry the air cooler by the handle (5).
12. Storage when not in use
If you do not plan to use the air cooler for some time, empty the water reservoir (13) and clean
the air cooler as described in the chapter on "Cleaning the air cooler". Reassemble it and allow
it to run for at least 4 hours at fan speed 3. This dries out the air filter (11) and the interior of the
device and prevents build-up of bacteria. Store the air cooler in a clean, cool, dry place.

Empty and clean the air cooler before storing it. Clean the air cooler before you use it again.
42 - English