Herunterladen Diese Seite drucken

Acoms TECHNISPORT V FIVE Bedienungsanleitung Seite 3

Digital proportional funkfernsteuerung
Vorschau ausblenden Andere Handbücher für TECHNISPORT V FIVE:

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

SAFETY
INSTRUCTIONS
R/C models can be dangerous and could cause personal injury or damaged to property.
Thus, for your safety and that of others,
1. Follow all the cautions, warnings, and instructions in this manual.
2. Be "Safety Conscious" and use common sense at all times.
3. Remember that operating any R/C model demands skills developed through proper
instruction and training - they are not acquired immediately.
4. Dont run risks, such as operating your model in adverse weather.
5. Warning: If you deliberately or accidentally turn on your transmitter while another model is
operating on the same frequency, both of those models will go out of control. The same will
happen if someone else does the same thing while your model is operating.
6.
Respect the rules of the track on which you operate your model.
7.
Running your model in the street is very dangerous to both automobile drivers and your
model. Avoid running your model in the street.
8.
Never aim or direct your model car at any person or animal. These model cars accelerate
very quickly and can cause serious physical injury.
9. You are responsible for animal safety when operating your model. Keep your model away
from any visible wildlife. On water, watch carefully out for fishing lines as these may
entangle the boat's propeller or in other ways disrupt the operation of the boat.
10. At any time during the operation of your model, should you sense, feel, or observe any
erratic operation or abnormality, end your operation. Do not operate it again until you are
certain that the problems have been fixed.
R/C Models are not "toys" - Safety precautions and good common sense are MUSTS! Take
your time to read all the way through the pages of this booklet before starting the installation of
this Digital Proportional Radio Control System.
Caution
Control of models is impossible with insufficient or no voltage in the transmitter or receiver. A
receiver battery that is too weak will move the servo(s) very slowly, and that may cause erratic
operation of your model. When using a car that operates both the electric motor and receiver
on the same battery, such as a BEC system, you should discontinue
the top speed becomes sharply reduced, otherwise loss of control will result soon afterwards.
Operation
Checks
Learn the proper sequence for switching on/off the transmitter and receiver for your model to
prevent a "runaway" accident.
* Before operation: Switch "on" the transmitter, then the receiver. Connect the
nicad battery to the motor lastly.
* After operation: Disconnect the nicad battery. Switch "off" the receiver, then
switch
"off" the transmitter.
* Be sure all trims and controls on the transmitter are set at neutral before and after operation.
2
operating the car when

Werbung

loading