Fault Diagnosis - MINDPRINT TRIO Handbuch

®
MindPrint T.R.I.O.
12. Troubleshooting
If you encounter problems when you're working with T.R.I.O™, run down the
following checklist. It will help troubleshoot errors.
The LED chain lights up to indicate an incoming microphone signal, but
I can't hear anything. Is the:
• MIC/INSTR. LEVEL knob in the monitoring section turned up? (see 3.1)
• MONITOR ON button engaged? (see 3.4)
• SPEAKERS A/B/C button engaged? (see 4.2)
• is there accidentally a jack in the INSERT RETURN? (see 1.9)
• MUTE button pressed? (see 1.6)
The microphone signal is audible, but I can't record it. Is the:
• REC VOL. knob of the microphone channel turned up? (see 1.5)
• ANALOG OUT LEVEL ADJUST knob turned down? (applies in case of an
analog connection to the DAW only; see 8.1)
• SYNC settings to DAW checked ? (see 8.4)
• proper setting selected in the recording software?
The microphone signal is audible on one speaker/headphones side only.
Is the:
• RECORD/MONITOR MODE SELECTOR on the bottom set to the correct
position? (see 9.1)
The record signal is distorted. Is the:
• GAIN knob turned up too high? (see 1.1/5.1)
• REC VOL. knob turned down too low? (see 1.5/2.5/5.1
The DAW's output is inaudible although visible. Is the:
• DAW ON button engaged? (see 3.5)
• ANALOG IN LEVEL ADJUST knob turned down? (applies in case of an ana-
log connection to the DAW only; see 8.2)
• SPEAKERS A/B/C button engaged? (see 4.2)
• proper setting selected in the recording software?
The line signal is visible on the right LED chain only (Switch set to
INPUTS):
• Only the right LED chain indicates the Line channel's input signal, even if
it's a stereo signal (see 5.1).
The AUX signal is audible, but I can't record it:
• The AUX input addresses the monitor section ONLY and cannot be
recorded – connect the source you want to record to the Line input!
22
y
Are all external devices powered up, fully functional and
connected correctly? Are you certain the cause is not a handling
error? Often enough, the complete service department was in big
insurrection until it turned out that a broken fuse or a wrong
connection was the reason.