Headphones Section; Phones A; Phones B - MINDPRINT TRIO Handbuch

®
MindPrint T.R.I.O.

6. Headphones Section

Connections:
Connect standard headphones to the two stereo 6.3 mm (1/4") jacks on the
rear panel. The two headphones amps are equipped with plenty of power
to drive even weaker headphones and deliver enough volume to enable
satisfactory monitoring.
Handling:

6.1 PHONES A

Twist this knob to adjust the first headphones output's
volume.

6.2 PHONES B

Twist this knob to adjust the second headphones output's
volume.
16
x
We strongly suggest that you always employ headphones with an
impedance greater than 30 ohms. Lower impedances or a short
circuit caused by mono jack plugs can do permanent damage to
T.R.I.O™'s headphones outputs.
x
Do not connect headphones to SPEAKERS A jacks because this can
harm T.R.I.O™.
y
Savvy recordists may want to use PHONES outputs for a purpose
other than intended – to connect further speakers via Y adapters
(stereo jack on one end; two mono jacks on the other), to drive
speakers sited in the studio's recording room. This lets you control
these speakers' volume separately and communicate with
musicians using the TALKBACK microphone. But whatever you do,
never insert mono plugs into the PHONES jack.
y For a happier and more congenial recording experience, it's a good
idea for the vocalist and producer to don the same model of head-
phones when tracking vocals.