BE QUIET! PURE POWER 11 FM Benutzerhandbuch Seite 6

Before using the power supply, allow it to warm up to room temperature
hour to prevent condensation accumulating in the power supply.
3. COMPATIBILITY
The be quiet! Pure Power 11 series power supplies are compatible with all recent
popular power supply and motherboard specifications
• Intel ATX12V Power Supply Design Guide Version 2.52
• ATX System Design Guide Version 2.2 and Version 2.1
• BTX Version 1.0a
• E-ATX Server Motherboards
• EPS12V version
• Intel C6/C7 Status for the new processor generation
• Energy Star 8.0 guidelines
• Erp guidelines
4. INSTALLING
Please read „Safety instructions"
Note: You will need a screwdriver to fit the power supply in your PC. Only use the
screws provided with the power supply because they have the correct thread.
Caution: Only use the supplied cable set. Using cables that were not included (e.g.
cables of older power supply unit series) may lead to defects!
First remove your old power supply. To do so, proceed as follows:
• Carefully disconnect
connected to the
• Open the PC case, taking care to follow the manufacturer's
• Disconnect all plugs from the motherboard and all other components,
FDDs, HDDs, or optical drives. Make sure that there are no plugs from the old
power supply connected to any of the components.
• Now remove the screws at the rear of the power supply and carefully pull the
power supply out of the PC case. Take special care that no cables get caught in
the components and damage them.
Fitting your new be quiet! Pure Power II power supply:
• Place the new power supply in the space provided in the PC case and connect to
the rear panel using the four screws provided. Do not use excessive force.
• Plug the 20/24-pin
6
via 8-Pin
2.92
YOUR NEW
before you begin the installation.
your PC from any power sources and unplug all cables
PC.
connector into the socket provided on the motherboard.
such as:
connector
POWER SUPPLY
for one
instructions.
such as
If