V-TAC VT-10-S Gebrauchsanweisung Seite 4

Note: When testing in daylight, please turn the LUX knob to " ☼ " (SUN)
position, otherwise the sensor lamp will not work.
• In front of the detection window please ensure there is no hinder or unrest
objects e ecting the detection.
TROUBLESHOOTING
1. Why does the sensor not switch OFF the light automatically?
• Please check if there is a continuous signal in the detection field.
• Please check if the time delay has been set to maximum.
• Please check if the power corresponds to the instructions.
• Please check if the temperature near the sensor changes such as air condition or central heating.
2.Why is the sensitivity of the sensor poor?
• Please check if there is any hinder in front of the detection window.
• Please check if the ambient temperature is too high.
• Please check if the induction signal source is in the detection field.
• Please check if the installation height corresponds as per the installation height mentioned on the
instructions.
IN CASE OF ANY QUERY/ISSUE WITH THE PRODUCT, PLEASE REACH OUT TO US AT: SUPPORT@V-TAC.EU
FOR MORE PRODUCTS RANGE, INQUIRY PLEASE CONTACT OUR DISTRIBUTOR OR NEAREST DEALERS.
V-TAC EUROPE LTD. BULGARIA, PLOVDIV 4000, BUL.L.KARAVELOW 9B