Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. Screw the drainage opening into the filter vessel.
6. Undo the locking ring
purpose.
7. Put aside the locking ring and its screws.
8. Slowly turn the filter vessel on its head and discharge the quartz filter sand or the filter balls.
9. Inside the filter vessel, pull the filter arms
10. Remove the screen.
11. Thoroughly rinse the screen and the filter arms under flowing water.
12. Rinse the filter vessel with clean water.
13. Carry out steps 4 to 12 as described in the "Preparing the filter vessel" section.
The filter medium is exchanged.
Cleaning
Only clean the device with a standard bathroom cleaner, clear tap water and a lint-free cloth. Aggressive
cleaning agents can damage the device. Dry the device with a lint-free cloth.
Test
Check the following before each use:
- Is there visible damage on the device?
- Is there visible damage on the control elements?
- Are the accessories in perfect condition?
- Are all lines in perfect condition?
- Is the feed unblocked?
- Are the ventilation slots clear and clean?
Do not start up a damaged device or damaged accessories. Have them checked by the manufacturer or
its customer service or a qualified service technician.
Storage
Winter storage
Store the filter system in a dry and frost-free place (>= +5 °C) away from direct sunlight.
Always store the dried filter medium separately from the filter vessel over the winter.
1. Switch the pump
2. Close the shut-off valves or block the water flow to the pool's connecting hoses.
3. Uninstall the connecting lines to the pool and drain the hoses.
4. Lift the pump and drain it via the two connections.
5. Drain the filter medium (see "Exchanging the filter medium").
If you are using filter balls, wash them by hand and let them dry completely. If you are using sand,
pour the sand into a suitable container (e.g. bucket) and store this in a dry place.
6. Rinse the filter system with tap water.
7. Let the filter system dry completely.
8. Press and hold down the valve lever
9. Turn the valve lever to the "WINTER" position and let go.
The device can be stored over the winter.
40
by turning the screw counter-clockwise. Use the Allen wrench
off the screen
off by pulling the power plug.
on the valve head
.
8
.
1
for this
Werbung
