Selecting the mode
Switch the pump
off by pulling the power plug.
Press and hold down the valve lever
position and let go.
Pump operation
1. Make sure that all hoses and pipes are correctly connected and that the water level in the pool is at
least 1 to 2" (2.5 to 5 cm) above the opening of the suction line.
2. Check the valve setting of your filter system before you activate the pump.
3. Connect the pump's power plug to the power supply.
The pump is running.
4. Check the pump for unusual noises.
If there is air in the system, bleed it again.
5. To stop pump operation, pull the power plug.
The pump is switched off.
Care instructions
The filter system cannot filter out algae, bacteria and other microorganisms.
- Use special water care substances to prevent and remove these to ensure hygienically clean
water.
- Consult an expert and observe the dosage.
Maintenance
Backflushing
Do not backwash when using Filter Balls. If the filter throughput decreases, we recommend
washing the filter balls by hand. If necessary, exchange the filter balls.
1. Switch the pump
2. Connect the backwash line (see section "Connecting the backwash line").
3. Press and hold down the valve lever
4. Set the valve lever to the "BACKWASH" position and release it.
5. Connect the pump's power plug to the power supply.
6. Backwash the system until clean water emerges from the backwash line (max. 2 minutes).
7. Switch the pump
8. Press and hold down the valve lever
9. Set the valve lever to the "RINSE" position and release it.
10. Connect the pump's power plug to the power supply.
11. Let the pump run for 20 to 30 seconds to remove any residue in the valve head.
12. Switch the pump
The backwashing is completed.
Exchanging the filter medium
The filter medium used (quartz filter sand or filter balls) should be exchanged every 2 to 3
years, depending on the operating period and the amount of dirt on the device.
1. Switch the pump
2. Close the shut-off valves or block the water flow to the pool's connecting hoses.
3. Screw in the drainage opening
4. Completely drain the water from the filter vessel
on the valve head
off by pulling the power plug.
on the valve head
off by pulling the power plug.
on the valve head
off by pulling the power plug.
off by pulling the power plug.
so that it comes out of the base of the filter vessel
. Turn the valve lever to the desired
1
.
1
.
1
via the drainage opening.
.
2
39