Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Only hand-tighten all screw connections. Excessive tightening of the screw connections
damages gaskets and plastic components. Do not use any tools.
You can use Teflon tape to seal screw connections with minor leakage.
1. Loosen the threaded ring
cover
by turning it counterclockwise.
2. Lift the prefilter cover
off the pump housing.
3. Insert the large O-ring seal
on the pump housing.
4. Insert the prefilter
The prefilter is already inserted into the pump
at the factory.
5. Place the prefilter cover
housing.
6. Guide the threaded ring over the prefilter
cover.
7. Turn the threaded ring clockwise until it is
hand-tight.
8. Insert the small O-ring seal
9. Screw the hose adapter
10. Place the medium O-ring seal
11. Screw a hose adapter
The pump is ready for operation. You can now connect it to the lines.
Mounting the pump on the base plate
1. Push the threaded screws of the fastening kit
for filter pumps
from below into the base
plate
(into the two hexagon sockets).
2. Place the pump
on the base plate
that the threads protrude through the fastening
opening in the pump base.
3. Push the washer and then the serrated lock
washer over the screw thread.
4. Put on one winged screw each and tighten it.
The pump is mounted on the base plate.
5. Connect the base plate
.
2
The base plate is connected to the filter vessel.
Preparing the filter vessel
1. Undo the locking ring
counter-clockwise. Use the Allen wrench
for this purpose.
2. Put aside the locking ring and its screws.
3. Mount the drainage screws set
drainage opening
24
34
on the prefilter
with the threaded ring
into the groove
into the pump.
on the pump
into the prefilter cover.
18
clockwise into the prefilter cover until it is hand-tight.
21
into the recess of the pump outlet
19
clockwise into the pump outlet until hand-tight.
21
so
to the filter vessel
by turning the screw
on the
.
1
5
4
18
20
32
.
28
2
3
21
19
28
Werbung
