Quick Setup - Genius Speedmaster X2 Bedienungsanleitung

Quick Setup:

①
Combine the wheel with its base, aligning them properly.
②
Once aligned, tighten by turning the nut on the base to the left.
③
Mount the steering wheel clamp, fitting desks 8mm to 55mm thick.
④
Remove the heightening buckle for thicker desks or attach it for thinner ones. Secure by
tightening the base's two screws.
⑤
Mount the gear shifter stick, loosen the clamp's screws, fit it under the gear stick, position it at
the table's edge, and tighten. Suitable for 8mm to 55mm thick tables.
⑥
Open the base's storage box to connect the gear shifter to slot 'B', pedals to 'C', and the
console's controller to 'D' at the wheel's back. Check connections to avoid malfunction. Storage
USB cables when not in use.
1
SpeedMaster X2