Ronix RP-1160 Bedienungsanleitung Seite 25

Fuse blows Fuse too small
- Air in inlet hose
Inadequate supply of
Machine mains water
pulsating - Nozzle partially blocked
water filter blocked
- Hose kinked
Machine often starts Pump/spray gun is
and stops by itself leaking Centre
- Pump/hoses or
accessory frozen
Machine starts, but
- No water supply
no water comes out
- Water filter blocked
- Nozzle blocked
- Change to an installation
higher than the amp
consumption of the machine
- You may try without the
extension cord
Allow machine to run with open trigger
until regular working pressure resumes
- Check the water supply corresponds to
specifications required
- Avoid using long, thin hoses (min1/2")
- Clean the nozzle
- Clean the filter
- Straighten out hose
Contact your nearest Service
- Wait for Pump/hoses or accessory to
thaw
- Connect inlet water
- Clean the filter
- Clean the nozzle
23
User Manual