Ronix RP-1160 Bedienungsanleitung Seite 24

TROUBLESHOOTING
Disconnect from the electrical power supply before carrying out
user maintenance or checking is correct functioning. To avoid
unnecessary disappointments, you should check the following
before contacting the service organization.
In case problems other than the above occur, please contact your
local distributor.
Symptom
Machine refuses to
start
Fluctuating pressure
Machine stops
22
Induction High Pressure Washer 160bar
Cause
- Machine not plugged in
- Defective socket
- Fuse has blown
- Defective extension cord
- Pump sucking air
- Valve is dirty, worn out
or stuck
- Pump seals worn out
- Fuse has blown
- Incorrect mains voltage
- Thermal sensor
activated
- Nozzle partially blocked
Recommended Action
- Plug in machine
- Try another socket
- Replace fuse
- Switch off other machine
- Try without the extension cord
- Check that hoses and connections are
airtight
- Clean and replace or refer to local
distributor
- Clean and replace or refer to local
distributor
- Replace fuse
- Switch off other machines
- Check that the main voltage corre-
sponds to specification on the model tag
- Leave the washer for 5 minutes to cool
down
- Clean the nozzle