Ronix RP-1160 Bedienungsanleitung Seite 20

- Connect the gun to high pressure hose.
- Connect the high pressure hose to the water outlet on the washer.
- Connect the water supply hose to female coupler. Then connect
to the water inlet of the washer. The supply hose must have an
internal diameter of at least 13mm (1/2 in) and must be reinforced.
the water supply must be at least equal to the washer delivery
capacity.
WARNING!
The intake water temperature must not exceed 40. The water
supply must not exceed 0.7 MPa.
CAUTION:
The washer must only be used with clean water; use of unfiltered
water of corrosive chemicals will damage the washer.
- Push the motor switch to "OFF" position.
18
Induction High Pressure Washer 160bar
Outlet