Ronix RP-1160 Bedienungsanleitung Seite 21

- Check that the electrical supply voltage and frequency (Volt/Hz)
correspond to those specified on the washer rating plate. If the
power supply if correct, you may now plug in the washer.
OPERATION
- Turn on the water supply tap fully.
- Release the safety lock then press the trigger for a few seconds
to allow air to escape and dis charge residual pressure in the hose.
- Keeping the trigger pressed, push the switch to start the motor
- When re-starting the motor, always keep the trigger pressed.
NOTE:
THE MOTOR ONLY RUNS WHEN THE TRIGGER IS OPERATED.
19
User Manual