Getting Started - Anker Nebula Capsule Bedienungsanleitung

EN

Getting Started

1. Placement
Place this device on a surface
front Of the projection surface
projection surface should
distance between this device and the projection
surface must be a minimum of 0.58 meters (23") and
a maximum of 3.08 meters (121") to get a projection
image from 20 to 00 inches,
•It is unnecessary
projection surface
projection image with the built-in keystone
correction.
he distance between
projection surface determnes
mage size. For the best result,
projection image ranging from 40 to 80 inches.
table, flat table in
For best results, the
be whlte and flat, The
to tilt it towards the
You can correct the
the device and the
the projection
set the
2. Preparing the Remote Control
O For first time use, remove the protective tab to
activate the remote control battery.
@ TOreplacethe battery,unlockandopen thebattery
compartment insert a new battery positionng the
polarity (+/-) as indicated, and then close and lock the
batterycompartment.
3. Get Started
O) Fullycharge the built-in battery before using for the
first time by using the provided cable and charger
@ Hold for 2 seconds on the projector to power
@Turn the devicetowards a suitable projecton
surface or wall.
@ Rotatethe focus by adjusting knobto getthe best
focus.
(b) For first time use, follow the on-screen instructions
to complete the basic settings.
_ To give your Nebula Capsule the fastest, safest
charge, use the supplied charger only.
EN
INPUT