ZENEC ZE-NC514 Benutzerhandbuch Seite 43

INSTALLATION AND UNINSTALLATION
Dashboard
Mounting Bracket
4. lnsert the unit into the bracket, fasten the M4 x 6 screw to the fireproofing board available
at the back of the dashboard, and use 4 pieces of M2 x 2 screw to lock the assemble
bars and the mounting bracket in position.
NOTE:
According to the depth of the opening, use different length of assemblebar accordingly.
If the opening is too shallow, the monitor may be extended out 10 mm from the
dashboard.
METHOD B
1. Insert this unit directly to the opening of the dash board.
2. Place M4 x 3, M5 x 5 cylindrical screw or M5 x 5 cone shaped screw through the holes
of the mounting frame located inside the opening to holes of the unit and fasten the
screws to left & right.
Rubber Sheath
Long Assemble Bar
(Picture 2)
43
Mounting Frame
ZE-NC514
Dashboard