Comedes Demecto 12 Bedienungsanleitung Seite 33

Empty the water tank:
When the water tank is full, the Comedes Demecto 12 switches off automatically and the tank
"full" indicator on the display lights up. This is also signalled acoustically.
You must empty the water tank to be able to put the Demecto 12 back into operation.
To do this, always switch off the unit first and disconnect the mains plug.
Now empty the water tank completely into a wash basin or similar.
If necessary, clean the inside and outside of the tank.
Carefully reinsert the tank after it
has been completely emptied. To
do this, grasp the water tank on
both sides and push it straight
into the appliance.
Make sure that the tank is
correctly inserted to ensure
proper operation of the appliance.
Attention:
To ensure correct and safe operation of the appliance, the float and its locking device
•
must not be removed from the water tank. Otherwise, this may cause the water tank to
overflow.
If the water tank is dirty, it should be cleaned. Use cold or warm water without
•
additives. Additives or cleaning utensils such as washing-up liquid, steel wool, benzene
or other chemical cleaners are not suitable as they can damage the tank and cause
leakage.
EN-12
Grasp the water tank by the two recesses on
the side and carefully pull it backwards out of
the appliance.
Caution: To avoid spilling water, it is
recommended to hold the water tank with
both hands when removing and transporting
it.
www.comedes.com