Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation instructions
Only operate the appliance in rooms with at least 6m².
Floor space
Remove all adhesive tapes that were used to secure the unit for transport.
Keep doors and windows closed to save more energy.
securely on firm, level and dry ground.
Never install the unit where it may be exposed to the following conditions:
Heat sources such as radiators, heat registers, stoves or other products that
o
generate heat.
In an area where oil or water may be splashed.
o
Direct sunlight
o
Mechanical vibrations or shocks
o
Excessive dust exposure
o
Lack of ventilation, e.g. in the cupboard or bookshelf
o
Uneven surface
o
Make sure that the socket outlet is equipped with an RCD circuit breaker (ground fault cir-
cuit interrupter). If you are not sure whether this is the case, you can ask your
electrician or use a personal protection plug (available in DIY stores).
To save power and avoid potential hazards, unplug the unit when not in use.
Keep at least 30cm distance around the unit from walls and objects. Make sure that the air
outlet is clear and that there are no curtains or textiles above it.
Before commissioning
After unpacking the unit, check it for completeness and possible transport damage to
avoid hazards. If in doubt, do not use it, but contact our customer service. The
service address can be found at the end of this manual. Please read the operating
instructions carefully before using your dehumidifier for the first time.
Your unit is packaged to protect it from damage during transport.
Carefully remove the unit from its sales packaging.
Remove all packaging parts.
Clean the unit and all accessories from packaging dust residues, according to the
instructions in the chapter "Maintenance".
Leave the unit in the final position for at least 24 hours before commissioning.
EN-9
Check that the appliance is standing
www.comedes.com
Werbung
