DCP W35 Bedienungsanleitung Seite 18

Dansk Centrifugalpumpefabrik
Installation, Operation and Maintenance Instructions
Pump type W
The following number indicates the
diameter of the impeller in mm.
Contact DCP for further information
concerning alloys
The number in the upper right corner is
a reference number for internal use
related to the testing of the pump.
Example of name plate:
Safety
The following
important safety information and are
relevant to all pumps from DCP.
5) The DCP pump is a pressure
vessel and a piece of rotating
equipment. All standard safety
precautions for such equipment
should be followed before and
during installation, operation and
maintenance.
6) For auxiliary equipment (motors,
couplings)
precautions should be followed
and relevant instruction manuals
consulted before
installation,
maintenance.
7) Do not operate the pump at low
or zero flow conditions for a
longer time
circumstances
cause the pumping liquid to
vaporize. Personal
damage to
result from the pressure created.
8) Should any
during dismantling or assembly
of the pump contact DCP for
advice.
warnings provide
standard safety
and during
operation and
or under
which could
injury or
equipment could
problems occur
18 of 41
warnings
In situations where
alertness is needed the text is marked:
Sound pressure level
The sound pressure level of the pump is
lower than the limiting values stated in
the EC Counsil Directive 2006/42/EF
relating to machinery.
pressure from the pump is to be
calculated from
pressure plus 2 dB(A). Please refer to
seperat motor manual.
Electrical installations
The electrical connections should be
carried out in accordance with local
regulations. The operating voltage and
frequency are marked on the nameplate.
Please make sure that the motor is
suitable for the electricity supply on
which it will be used.
Never
connections in the pump
terminal box unless the
electricity supply has been
switched off. The pump
must be connected to an
external mainsswitch.
exceptional
The sound
the motor sound
make any