Changing The Oil; Environmental Protection - Ronix Rc-2510 Bedienungsanleitung

4- Install new air filter.
5- Replace the air filter cover and secure it by turning it clockwise.

CHANGING THE OIL

Replace the oil after the first 10 hours of operation and every 100 hours
following the oil change.
The sight glass, located above the tank, indicates the oil level and lets
the operator see at a glance if oil should be added.
1- Place as suitable container underneath the drain to collect used oil.
2- Remove the drain plug with an 8 mm socket or wrench.
3- When the used oil has drained, reinstall the drain plug and tighten
with the wrench.
4- Unscrew the cap of oil fill hole.
5- To refill, use a funnel to pour oil into the hole. Refill only with synthetic
oil fil SAE 5W40.
NOTE:
Avoid refilling with too much oil. Ensure that the level of the oil does not
exceed the top of the red dot at sight glass. The recommended amount of
oil for refilling is 250ml.
1- Tighten the cap securely into the fill hole.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing of as waste. The machine,
accessories and packaging should be sorted for environmental-friendly
recycling.
30
Air Compressor 25L