Ronix RC-2510 Bedienungsanleitung Seite 28

5- Connect the power cord to the power supply.
6- Turn the switch ON (1).
7- Pull out and rotate pressure regulator knob to desired line pressure
at the outlet; turning counterclockwise regulator knob to desired line
pressure. Turning the knob clockwise increases air pressure at the
outlet; turning counterclockwise reduces air pressure at the outlet.
8- Following all safety precautions in the air tool manual. You may now
proceed to use your air-powered tool.
WARNING!
Air-powered tools may require more air consumption than this air
compressor is capable of providing. Check the tool manual to avoid
damage to the tool or risk of personal injury.
1- Control the amount of air flow with the pressure regulator knob.
Turning the knob fully counterclockwise will completely stop the flow
of air.
NOTE:
Always use the minimum amount of pressure necessary for your
application. Using a higher pressure than needed will drain air
from the tank more rapidly and cause the unit to cycle on more
frequently.
1- When finished, always drain the tank and unplug the unit. Never
leave the unit plugged in and/or running unattended.
2- Recommended for the use of a residual current device with a
rated residual current of 30mA or less.
DRAINING THE TANKS
To help prevent tank corrosion and keep moisture out of the air, used,
the air tanks of the compressor should be drained daily.
TO DRAIN
1- Turn the air compressor off.
26
Air Compressor 25L