Commodore 1084S Bedienungsanleitung Seite 5

Rear
4
123
(l) Powe r Cord Connect or —A three-prong
er pow cord . Allows y ou toconnect your m onitor toanelectrical
source.
—-Phonojacksfor connecting the audio
(2) Right and (3) Left Audio
outputs of the Amigato themonitor.
(3 ) Left A udio , (4)Video, (5)ChromaThree p hono jacks f oruse w ith
a 64 or 128compute r withan8-pinDINvideo connector. This
provide s d Separate Audio Luma-Chroma-
Set the switch to ANALOG for an Analog
RGB Mode Switch
RG B displa y foruse withanAmiga c omputer. Set t heswitch t oTTL
for aDigitalRGBIdisplay for usewithaPCor C12B.
(7 ) RG B Input—A9-pin D connector foruse withanAmiga c omputer,
Commodore PC or Commodore 128.
(8 ) Vertica l [leight Adjusts theimage h eight onthescreen, DONOT
useascrewdriver to make anyadjustments; useaplasticadjustment
tool o nly. I nsertin g metal tools intothe cabinet may pose a nelectrical
shockhazard.Plasticadjustment toolsareavailable at mostelectron•
ics stores.
View
8
7
56
connector foruse withthe
input.
3
For an Analog RGB Display with an Amiga computer
Firsts connect the video cuble, Simply insert the small, rectangular 9•pin
D connectorinto the port labeled RGB Input on the back of your 1084.
Then insert the other end of the cable with the large, 23-pin RGB
connector into the video port on the back of your Amiga- Tighten the
screws that are on each side of the connectors,
To use the 1084 in Analog RGB mode, you must set the Video Mode
Switch on the front of the monitor to the RGB position. The RGB Mode
Switch on the rear of the monitor should
To connect the audio, one pair of phono plugs are connected to the left
(white) and right (black) audio jacks on the back of your monitor, and the
otherpairof plugsareinserted into theAmiga's left andrightaudioports.
The cable jacks are colour coded. Be sure to insert the plug into the jack
of the same colour,
For a Digital RGBI Display
With a Commodore PC or Commodore
rectangular, 9-pin D connectors on eachend- Insert one end into the port
labeledRGB Input on the back of your 1084.Then insertthe otherend of
the cableinto the video port on your computer.CBesureto tighten the
screws on each side of the connectors.) Depending on which computer
youhave,thevideoport maybe labeledVideo or RGBI —or it may not
be labeled at alL
Be sure to set the Video Mode Switch
Then set the RGB Mode Switch on the rear of the monitor
For a Separated Luma-Chroma-Audio
Wilh a Commodore 128 or Commodore
three phono plugs, and insert the plugs into the ports labeled Video,
Chroma, and Left Audio on the back of the 1084, The cable jacks are
colour coded, so be sure to insert the jack into lhe port of the same colour:
Video Yellow Chroma
Then insert the 8-pin DIN connector into the Video port on your comput-
ere Be sure to set the Video Mode
SEP.
be set to ANALOG,
128— Take the cable with
on the front of the monitor to RGB.
to TTL,
Display
64 — Take the cable with the
Red Audio White
Switch on the fiont of the monitor
4
the
to