Environmental Protection; Technical Specifications - Metabo Rfev 19-125 Rt Originalbetriebsanleitung

en ENGLISH

14. Environmental Protection

The sanding dust generated may contain
hazardous materials: do not dispose of this dust
with household waste, but at a special collection
point for hazardous waste.
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Packaging materials must be disposed of according
to their labelling in accordance with municipal
guidelines. Further information can be found at
www.metabo.com in the "Service" section.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Guideline 2012/
19/EU on used electronic and electric equipment
and its implementation in national legal systems,
used power tools must be collected separately and
handed in for environmentally compatible recycling.

15. Technical specifications

Explanation of details on page 3. Subject to change
in line with technical advances.
D = max. diameter of accessory
max
t = Max. permitted thickness of clamping
max,1
shank on accessory when using
clamping nut (10)
M = Spindle thread
l = Length of the grinding spindle
n* = No-load speed (maximum speed)
P = Nominal power input
1
P = Power output
2
m = Weight without mains cable
Measured values determined in conformity with
EN 62841.
Machine in protection class II
~
Alternating current
* Energy-rich, high-frequency interference can
cause fluctuations in speed. However, the
fluctuations disappear as soon as the interference
fades away.
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
Using these values, you can estimate the
emissions from this power tool and compare these
with the values emitted by other power tools. The
actual values may be higher or lower, depending on
the particular application and the condition of the
tool or power tool. In estimating the values, you
should also include work breaks and periods of low
use. Based on the estimated emission values,
specify protective measures for the user - for
example, any organisational steps that must be put
in place.
Vibration total value (vector sum of three directions)
determined in accordance with EN 62841:
a = Vibration emission level
hV
(grinding)
K = Uncertainty (vibration)
16
h,...
Typical A-effective perceived sound levels::
L = Sound pressure level
pA
L = Acoustic power level
WA
K , K = Uncertainty
pA WA
During operation the noise level can exceed
80 dB(A).
Wear ear protectors!