Using The Appliance; Maintenance And Cleaning; Technical Data - Ecg Rk 1712 Surfer Bedienungsanleitung

lid, the outer surfaces are hot. Do not use the appliance close to objects
which can be damaged by steam.
Do not immerse in water! – Do not immerse in water!
CAUTION
1. Always use cold water when filling the kettle.
2. The water level must be between the MAX. and MIN. levels!
Hot water may spurt out if the kettle is overfilled.
3. Switch off the kettle before removing it from the base.
4. Always make sure the lid is well closed.
5. The base and kettle body should not be wet.
6. Only use the kettle in combination with its original base.
You may not use the kettle to heat any other liquids than water. Never put in the kettle tea bags, loose
tea or any other ingredients for making beverages!

USING THE APPLIANCE

Remove and wash them before first use with an ordinary detergent used for washing dishes. Then rinse with
lukewarm water.
Fill the kettle with clean, cold and potable water up to max. level before first use, switch it on and bring the
water to a boil. Then pour the water out and repeat the procedure at least five times. With this procedure you
will properly clean the kettle and remove any possible after-taste. If you have the impression that you taste
plastic from the boiled water, we recommend to repeat the procedure. It is also recommended the leave the
empty kettle open for 24 hours. The kettle material coming into contact with water is certified as harmless to
health. Any slight "smell" or "after-taste" during initial use after unpacking kettle is a normal phenomenon and
should not be cause for return of the appliance.
You should boil clean water in the kettle five times before using it for the first time.
1. Place the base on a flat and stable surface. Unwind the mains cable from the storage compartment of the
base at the optimum length.
2. Place the kettle on its base.
3. Fill the kettle with water.
4. After plugging the appliance into an electrical outlet, turn on the kettle by sliding the switch down to the
"I" position. The switch lights up blue while the kettle is heating.
5. The kettle will switch off automatically after the boiling process has finished. The switch returns to the "O"
position and the blue light goes out. The boiling sequence of the kettle can be interrupted at any time by
moving the switch back to the "O" position.
6. Unplug the cord from the outlet.
7. Do not open the lid when pouring the water out. Pour the water out using the spout (2).

MAINTENANCE AND CLEANING

Before cleaning the kettle always disconnect the power supply plug from the wall outlet and make sure the
kettle is cold! Wipe the outside of the appliance with a moist cloth and then wipe dry. The scale filter can be
removed for the cleaning process. Use designated and commonly available agents to remove scale from the
kettle.

TECHNICAL DATA

1.7 l capacity
Nominal voltage: 220–240 V~ 50/60 Hz
Nominal input power: 1850–2200 W
6
RK 1712 Surfer_manual_cz_sk_pl_hu_de_en_hr_si_sr_et_lt_lv_el_ro_uk.indb 6 RK 1712 Surfer_manual_cz_sk_pl_hu_de_en_hr_si_sr_et_lt_lv_el_ro_uk.indb 6 18.07.2024 11:33:13 18.07.2024 11:33:13