RONDELL RDE-1702 Betriebsanweisung Seite 17

TROUBLESHOOTING
Malfunction Possible cause
One of the frying plates Removable plate is not installed properly. Unplug the unit from the mains socket.
doesn't heat up.
Electrical wiring of the unit is
malfunctioning.
Electrical control unit is malfunctioning
Heating element is malfunctioning
The unit does The power plug is not completely
not switch on. inserted into the socket.
Mains socket is malfunctioning.
RCD actuated.
The display doesn't show The temperature probe is malfunctioning. Replace the temperature probe with a good
the temperature readings
when you connect the
Electrical control unit is malfunctioning
temperature probe.
The working plates The temperature sensor works
heating doesn't switch improperly
off.
Error E1 appears There was an open circuit of the
on the display temperature sensor of the upper working
plate
Error E2 appears There was a short circuit of the
on the display temperature sensor circuit of the upper
working plate
Error E3 appears There was an open circuit of the
on the display temperature sensor of the lower working
plate
Error E4 appears There was a short circuit of the
on the display temperature sensor circuit of the lower
working plate
Error E5 appears There was a short circuit of the
on the display temperature probe circuit
Solution methods
Install the removable plate until clicking and
switch the unit on again.
Contact the service center
Contact the service center
Contact the service center
Insert the power plug into the mains socket
completely.
Connect the unit to another socket.
Unplug the unit from the mains socket.
Eliminate the possible cause of the RCD
actuation.
If the problem remains, apply to the service
center.
one.
Contact the service center
Contact the service center
Unplug the power cord from the mains socket
and contact an authorized service center
Unplug the power cord from the mains socket
and contact an authorized service center
Unplug the power cord from the mains socket
and contact an authorized service center
Unplug the power cord from the mains socket
and contact an authorized service center
Unplug the power cord from the mains socket
and contact an authorized service center
17
ENGLISH