Label Application; Adjust Shifter Position - Ascher Racing B24L Produktanleitung

Settings tab)
-
alternative connection:
-
•
pull both paddle shifters simultaneously to connect immediately
•
pull both paddle shifters simultaneously for 5s to disconnect
after driving session, it is recommended to switch-off/ disconnect the wheel to avoid constant
-
battery drain in specific circumstances when a connection to SC is active
expected battery life of 2 - 3 years on heavy daily usage
-
low battery voltage: True Drive will show a warning message, SC2 will play an audible beep
-
remaining energy will still last for many days to have time for replacing the battery
-
to swap batteries, open access window on the rear side (1.5mm allen key required)
-

8. Label Application

encoder knobs must be removed to apply label (hex wrench)
-
to apply button labels the easiest way use a tool such as a knife
-
put the label on the very tip of the knife
-
position label centered and horizontal
-
press the label on the surface
-

9. Adjust Shifter Position

- to achieve the most comfortable ergonomics, paddle location is adjustable
- paddle shifters can be moved inwards by 9.5 mm each:
1. open button plate by removing Binder connector nut on the rear side (required tool included)
2. remove 4 x screws (hex wrench) on the frontplate
3. unmount paddle shifters (hex wrench)
4. mount shifters to alternative mounting position
5. inward screws (now located inside the casing) must be replaced with supplied shorter ones
- paddle can be moved closer to the wheel rim:
mount paddle to the lower side of the shifter lever arm
•
for additional adjustment, 5mm paddle spacers are available separately
•
ENGLISH | GERMAN
5 | p a g e