3. Box Contents
The box contains the following components and accessories:
- B24L | B24M button plate
- alternative magnets to adjust paddle shifter force (please check foam insert!)
- screws and washers for wheel and Quick Release mounting
- button and encoder label sheets
4. General Information
- Wireless connection to SC1 & SC2
- mass: 700 g
- 3,6V lithium battery (ER14250)
- standard 6 x 70mm bolt pattern (through hole) to mount quick release
- 24 inputs in total (+2 additional button inputs via std. 0.1'' jumper connector)
- do not apply excessive force on the antenna; handle with care (e.g. laying wheel on a table)
- for compatible steering wheel rims refer to the list on the product page
5. Quick Release Mounting
The B16 button plates are equipped with a standard 6 x 70mm bolt pattern with M5 through holes. Steering
wheel rim, button plate and QR need to be assembled before use. Bolts for the most common applications
are supplied.
Button plates are compatible with standard 70mm QRs (with a maximum outer diameter of 88mm) such
as:
- Simucube SC2 QR
- Asetek Invicta QR
- Buchfink Q1R
- NRG QRs
6. Initial Operation
open True Drive/ Simucube Configuration Tool and go to Simucube Wireless Wheels tab
-
set checkmark: Connect automatically to paired devices
-
switch on steering wheel (ON-OFF switch on the rear side)
-
double click Ascher Racing B24
-
wheel is now paired, connected and shows up in the Overview tab
-
check connection signal quality (Overview tab) for a full rotation of the steering wheel
-
signal quality must be above 20% at all times for perfect operation´
-
7. General Operation
when switched ON, the wheel will go into discovery mode for 30s (blinking LED)
-
if Simucube is switched on, it connects automatically and shows up in the Overview tab
-
LED will indicate successful connection by blinking three times
-
SC2 will indicate connection/ disconnection by an audible beep (if checked in the Hardware
-
ENGLISH
| GERMAN
4 |
p a g e