Mode-Switches; Simucube Button - Ascher Racing F64-Sc V3 Produktanleitung

Mode-Switches

The rear side of the steering wheel features 2 mode switches which change the behavior of the rotary
switches (located on the same side of the steering wheel) in order to maximize the performance and
functionality.
⎯ 12-pos: standard mode (each position is an individual output)
⎯ shift: (rotary can't be used in the simulation)
•
each rotary position changes the output of the middle thumb encoder
•
adjust 12 controls with one physical encoder
•
e.g. pos. 1 = ABS / pos. 2 = TC / pos. 3 = MAP / pos. 4 = Volume ...
•
left rotary switch shifts left middle thumb encoder and vice versa

Simucube Button

The left joystick push button acts as a Simucube Button which allows changing of force feedback
parameters on-the-fly.
⎯ enter SC Button Mode by pushing left joystick button for 1s
⎯ select parameter by pushing joystick in a direction
•
Up: Overall Strength
•
Left: Damping
•
Right: Simucube Force Reconstruction Filter
•
TBD
⎯ increase/ decrease parameter by rotating the joystick encoder
⎯ holding the direction for more than 2s resets the parameter to previous value
⎯ exit SC Button Mode by pushing left joystick button for 1s
Each point above will give a recognizable audible feedback (if enabled).
ENGLISH | GERMAN
12 | p a g e