EBERTH IW8-PAS Bedienungsanleitung Seite 25

• Make sure that your work area is always clean and well lit. Disorder in the workplace
can quickly lead to accidents.
• Even after disconnecting the device from the compressed air source, there may still be
residual air in the device! Therefore, press the trigger a few times to allow the residual
air to escape from the appliance!
• Always wear safety goggles and personal protective equipment when working with
the appliance! This reduces the risk of injury.
• Wear personal protective equipment such as a dust mask, non-slip safety shoes, hard
hat and hearing protection as required. Wear work gloves every time you use them!
Only change the sandpaper on the unpressurized appliance. Always
disconnect the device from the pressure supply before removing the
sandpaper used.
Even after disconnecting the device from the compressed air source, there may
still be residual air in the device! Therefore, press the trigger a few times to
allow the residual air to escape from the appliance!
Avoid idle operation.
Disconnect the appliance from the compressed air supply before
troubleshooting, maintenance work or changing sandpaper.
EN V. 1.1
7