Maintenance; Cleaning The Remote Control - Vermeiren Vancouver Gebrauchsanweisung

GB
Usage of the buttons:
→ When the liftchair is not being used, leave it
the sitting position and not in the elevated pos-
tion.
SAFETY
→ Please do not exceed the maximum users
weight of 150kg.
→ Be extremely careful in the presence of chil-
dren or pets.
→ Do not allow children to be under the chair,
use the chair or play with it because it might
cause injuries when the legrest are folding.
→ If the wheelchair blocks in the lying position,
you must ask assistance to leave the chair.
→ Please do not place the liftchair near any
heat source or type of electric radiator, fire-
place, radiator or radiator with flammable li-
quid because the coatings are not fire-resistant.
Never smoke when seated in the liftchair.
→ It is strongly recommended not to operate
the liftchair near a desk or a wall too close to
it, as not to cause damage by tilting the back
or the legrests.
→ If you need to retrieve a fallen object under-
LIFT FUNCTIONS
Stepless adjustment from
sit-position to lift-posi-
tion.
LAY BACK FUNCTION
Stepless adjustment to
stretched position
neath the seat, disconnect the front to avoid get-
ting stuck.
→ For prolonged use of the liftchair motor
(about 2 min), you'll have to wait a few minutes
before reusing it. This is needed to avoid over-
heating the liftchair motor.
→ Do not move the liftchair:
* when the liftchair is in the lying position;
* when the liftchair is connected to the power
and/or in service.
→ Be careful not to sit on the armrests or on the
legrest.

MAINTENANCE

→ Inspect your liftchair regularly to detect any
damage on the coating, framework or loose.

CLEANING THE REMOTE CONTROL

Before starting, it's important to unplug the
power cord. The remote can be cleaned with a
dry cloth but do not use any agressive cleaning
products.
Do not use your liftchair if you notice any de-
fects but contact your local dealer.
CLEANING THE COATING
You can clean the artificial leather parts with
warm water. In case of stubborn dirt, you can
wash it with a non-abrasive cleaning product
but do not use solvents or hard brushes. You
can remove stains with a sponge or soft brush.
We strongly advise you to first test the cleaning
product on a hidden part of your liftchair. Al-
ways avoid wet surfaces, especially the fabric.
Never wash your liftchair with plenty of water.
Do not wet the electrical parts.