Werbung
10. Error codes
Any malfunction during operation may be identified by an error
message on the display. Proceed as follows in such cases:
1- Switch off the device using the power switch.
2- Carry out corrective measures (see table below).
3- Restart the device.
Error code Cause
Error 3
Inside
temperature is
too high
Error 4
Motor cannot
run normally
(cannot start
of unable to
reach the
target speed)
Error 47
Overload
Error 48
Error 50
Rotor is
protected
to prevent
overload
INSTRUCTIONS FOR USE
Effect
motor off
motor off
motor off
motor off
Device exterior labelling
1 - Information.
Label present on the back
of the equipment next
to the power connector,
in accordance with the
requirements established
in the CE Directive.
Solution
- Switch off the
device and let it
cool down.
- Restart the device
- Switch off the
device.
-Check the
structure for
possible blockages
-Switch off the
device
-Decrease the
speed setting of the
load
- Switch off the
device
EN
11
Werbung
