cecotec CONGA 7000 CARPET&SPOT CLEAN STEAM XXL Bedienungsanleitung Seite 28

ENGLISH
2. Fitting the hose (Fig. 4)
Hold the hose close to the connector and push it slightly in the direction of the arrow. After
hearing a click, pull the hose in the opposite direction to make sure it does not come out.
3. Storage
After use, the hose can be coiled up in the cord winder, which is located at the bottom of the
upholstery cleaner.
Warning
- It is normal for the surface to be wet after spraying.
- Do not spray water continuously over the same spot.
- Switch off the appliance before unplugging it.
- After use, hang the coiled power cable on the power cable holder.
5. CLEANING AND MAINTENANCE
Cleaning embedded dirt
Warning:
- You can add low-foam detergent in the clean-water tank or apply it directly on the stain.
- Make sure the detergent will not damage the soiled surface before using it.
- Do not use thinners, aniline, chloroform, or flammable detergents.
Recommended liquids
- Alkaline ionised water.
- Low-foam detergent to the clean water tank combined with water in a 5:10 proportion.
- Citric acid
- Water with hydrochloric acid.
Non-recommended liquids
- Neutral kitchen detergent
- Alkaline detergent
- Acid detergent.
1. Apply detergent over the soiled surface, spray clean water, and scrub the dirt with a brush
to bring it to the surface.
2. Vacuum the dirt and do not let any detergent remain.
Warning:
- To know the detergent quantity and use, carefully read the manufacturer instructions.
- Stop using the appliance when the water or foam in the waste-water tank reaches the
CONGA 7000 CARPET&SPOT CLEAN STEAM XXL
54
maximum water level and clean the waste-water tank. Otherwise, water may enter the
appliance.
Warning
- This appliance is designed to clean soft fabrics such as cloth and plush.
- It is not recommended for use on hard surfaces.
- When using the upholstery cleaner, water should first be sprayed on and then vacuumed
up. Do not vacuum up dirt directly, as this appliance is not a vacuum cleaner.
Warning
- Stop the appliance and unplug it from the mains before cleaning it.
- Do not wet the appliance to avoid the risk of electric shock.
- Do not use detergents, thinners, benzene, or other chemical agents to clean the appliance.
- After every use, you must remove and clean the waste-water tank, the clean-water tank,
and the suction nozzle to prevent humidity and dirt remains from emitting bad odours.
5.1 Cleaning the main body
- The most common dirt can be cleaned with a slightly damp cloth.
- The most stubborn dirt can be cleaned with a cloth slightly soaked in detergent and then
a cloth slightly soaked in water.
5.2 Waste-water tank cleaning Fig. 5
1. When the wastewater reaches the maximum level, stop using the appliance and unplug it
from the mains.
2. Remove the waste-water tank. To do so, slide the waste-water tank release tab and
remove the waste-water tank.
3. Remove the upper cover of the waste-water tank and empty the wastewater.
4. Clean the tank, the top cover and the sealing strip.
5. Place the waste-water tank in the main body of the appliance.
Warning
- Do not lean or shake the waste-water tank when transporting or assembling it; otherwise,
wastewater will easily leak.
- We recommend you empty the wastewater before it exceeds the maximum level on the
tank; if you continue using the tank after the wastewater has exceeded the maximum
water level, the appliance will automatically stop vacuuming up water.
- To maintain the performance of the upholstery cleaner, clean the waste-water tank
regularly. If the water in the tank is too dirty, the suction power will decrease. In addition,
the waste-water tank must be cleaned when the water level reaches the "MAX" mark.
ENGLISH
CONGA 7000 CARPET&SPOT CLEAN STEAM XXL
55