Herunterladen Diese Seite drucken

cecotec CONGA 7000 CARPET&SPOT CLEAN STEAM XXL Bedienungsanleitung Seite 27

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 35
ENGLISH
-
Clean-water tank
-
Waste-water tank
-
Self-cleaning accessory
-
Extra pack of sealing rings
-
Hose
-
Instruction manual
3. OPERATION
Control panel
Fig. 3
1.
Power icon
2.
Power setting icon
3.
Normal power indicator light
4.
Maximum power indicator light
5.
Cold water indicator light
6.
Hot water indicator light
7.
Mode selection icon
8.
Steam indicator light
1.
Power icon
If you press the power icon
, it will light up white and flash. If you press the icon again,
the indicator light will remain fixed and the appliance will start (by default, the power will be
normal
and the water will be at room temperature). If you press this icon again, the device
will enter standby mode and the white indicator light will flash again.
2.
Power setting icon
The default power on switch-on is normal
press it again, the upholstery cleaner will go back to normal speed. When selecting a power
setting, the corresponding indicator light will light up.
3.
Mode selection icon
By default, when the appliance is switched on, water will be discharged at room temperature
. Press
to make hot water come out
will release steam
. If you press it a third time
temperature
again.
NOTE: when selecting a mode, the corresponding indicator light will light up.
Warning
You can only use the control panel when the power switch is in the on position.
CONGA 7000 CARPET&SPOT CLEAN STEAM XXL
52
. To select maximum power
, press
. If you press it again, the upholstery cleaner
, the appliance will expel water at room
4. USING THE APPLIANCE
1.
Place the appliance on a flat surface before switching it on. Make sure that the voltage and
socket match the required voltage and check that the hose is correctly connected.
2.
Then, remove the clean-water tank, open it and fill it (the water temperature must not
exceed 40 °C).
3.
Connect the appliance to the mains socket.
4.
Make sure that the switch is set to the on position and wait 3 seconds.
5.
Press the power icon
indicator light will remain fixed and the appliance will start (by default, power will be
normal
will enter standby mode and the white indicator light will flash again. If no operation is
performed after 30 minutes, the white indicator light will go out.
6.
The default power on switch-on is normal
you press it again, the upholstery cleaner will go back to normal speed.
7.
Press and hold the water/steam sprayer button to spray clean water. Spray clean water
on the dirt to bring it to the surface. If you stop pressing it, the upholstery cleaner will stop
releasing water/steam.
NOTE: if you do not want to hold down the button during the entire cleaning process, slide it
upwards so that it stays in position.
8.
By default, when the appliance is switched on, water will be discharged at room temperature
. Press
will release steam
temperature again
up.
9.
Press the suction inlet on the dirt to bring water and dirt to the surface and vacuum them.
10.
Stop spraying clean water and vacuum the wastewater.
. If you
11.
Switch off the appliance by pressing the power icon
12.
Unplug it from the power supply.
13.
Empty the clean and wastewater from the tanks and clean the waste-water tank.
NOTE:
-
Water/steam spraying is suitable for cleaning sofas, carpets, among others. When you
have finished spraying, use the accessory to wipe away stains and soak up dirty water.
Waste water shall be channelled to the corresponding tank.
-
Use the different accessories according to your needs.
Before using the upholstery cleaner
1. Disassembly (Fig. 3)
Hold the hose near the end of the connector by hand. Next, press the hose locking piece with
your thumb and pull it straight out in the direction of the arrow. Please note that after steam
cleaning, the hose must not be removed until the machine cools down completely.
, it will light up white and flash. If you press the icon again, the
and water will be at room temperature
). If you press this icon again, the device
. To select maximum power
to make hot water come out
. If you press it again, the upholstery cleaner
. If you press it a third time, the appliance will expel water at room
. When selecting a mode, the corresponding indicator light will light
CONGA 7000 CARPET&SPOT CLEAN STEAM XXL
ENGLISH
, press
. If
.
53

Werbung

loading

Diese Anleitung auch für:

A01 eu01 100075