Roidmi EVA Benutzerhandbuch Seite 8

Product Use
Quick Installation and Use
First, remove the protective material from the limit strips on both sides of the bumper.
Then paste the mop on the mop support sticking area and install the mop support
component into the bottom groove.
Next, find a suitable location to place the base station and ensure that it is placed
horizontally. Take out the water tank, remove the lid and fill it with clean water (the
water volume should be below the MAX line). Then put back the clean water tank into
the base station and cover the base station.
Finally, connect the base station to the power supply and shown in the figure below,
press the recharge button to actively search for the robot cleaner for charging.
8
Recharge button
Water inlet
MAX line