Technical Information - Philips GC9644 Gebrauchsanleitung

Problem
Dirty water and impurities
come out of the soleplate
or the soleplate is dirty.
The iron leaves a shine or
an imprint on the garment.
The appliance does not
produce any steam.
The appliance has
switched off. The light in
the on/off button flashes.
The appliance produces a
pumping sound.
Possible cause
Impurities or chemicals present
in the water have deposited in
the steam vents and/or on the
soleplate.
Too much scale and minerals
have accumulated inside the
appliance.
The surface to be ironed was
uneven, for instance because you
were ironing over a seam or a
fold in the garment.
There is not enough water in
the water tank (the 'water tank
empty' light flashes).
The appliance is not hot enough
to produce steam.
You did not press the steam
trigger.
The water tank is not placed in
the appliance properly.
The appliance is not switched
on.
The auto-off function is activated
automatically when the appliance
has not been used for more than
10 minutes.
Water is pumped into the boiler
inside the appliance. This is
normal.

Technical information

- Rated voltage: 220-240V
- Rated frequency: 50-60 Hz
ENGLISH
Solution
Clean the soleplate with a damp cloth.
Descale the appliance regularly (see
chapter 'Cleaning and maintenance',
section 'EASY DE-CALC').
PerfectCare is safe on all garments.
The shine or imprint is not permanent
and will come off if you wash the
garment. Avoid ironing over seams or
folds or you can place a cotton cloth
over the area to be ironed to avoid
imprints at seams and folds.
Fill the water tank (see chapter
'Using your appliance', section
'Filling the water tank').
Wait until the 'iron ready' light on the
iron lights up continuously.
Press the steam trigger and keep it
pressed while you iron.
Slide the water tank back into the
appliance firmly ('click').
Insert the plug in the wall socket and
press the on/off button to switch on
the appliance.
Press the power on/off button to
switch on the appliance again.
If the pumping sound continues
nonstop, switch off the appliance and
remove the plug from the wall socket.
Contact an authorised Philips service
centre.
19