Vertical Ironing; Eco Mode; Turbo Steam Mode - Philips GC9644 Gebrauchsanleitung

Vertical ironing

For vertical steaming, we advise you to switch to the TURBO steam mode.
- Put the garment that you want to steam on a clothes hanger and
hang it from e.g. a hanging rack. Hold the iron in vertical position.
Pull the garment with one hand and stretch it slightly for more
effective wrinkle removal. While pulling the garment, press the steam
trigger and move the iron up and down.
4 When you put down the iron during ironing, put it on the iron
platform or place it on the ironing board in horizontal position,
on its soleplate.
Hot steam is emitted from the iron. Never attempt to remove wrinkles
from a garment while someone is wearing it. Do not apply steam near
your or someone else's body to prevent burns.
Note: Regularly water is pumped into the boiler inside the appliance again,
which causes the appliance to produce a pumping sound. This is normal.

ECO mode

During ironing, you can use the ECO mode to save energy but still have
sufficient steam to iron all your garments.
Note: For the best results, we advise you to use the normal steam mode.
1 Press the ECO button.
The ECO button lights up green.
,
2 To switch back to the normal steam mode, press the ECO button
again.
The green light in the ECO button goes out.
,

TURBO steam mode

The TURBO steam mode has a higher amount of steam. You can use it
for thick garments to have better steam penetration.
Note: As the TURBO steam mode produces a high amount of steam, the
supply hose may become hotter than at the normal steam and ECO modes.
2 sec.
This is normal.
1 Press and hold the on/off button for 2 seconds until the light
turns white.
, The 'iron ready' light on the iron and the white TURBO light in the
on/off button start to flash to indicate that the iron is heating up to
the TURBO steam mode. This takes up to 2 minutes.
2 To switch back to the normal steam mode, press and hold the
on/off button for 2 seconds until the light turns blue again.
ENGLISH
13