Oase Bitron C 24 W Gebrauchsanleitung Seite 25

Commissioning/start-up
NOTE
The unit may be damaged, if the water flow is suddenly interrupted downstream of the outlet
(e.g. by a slide valve). The sudden interruption can cause a temporary pressure increase of over
1 bar (hydraulic shock).
 Switching off: First switch off the pump, then close the slide valve. If the unit is operated in a
filter system, first take the filter system out of operation.
 Switching on: First open the slide valve, then switch on the pump. If the unit is operated in a
filter system, start up the filter system last.
 As an alternative, install the slide valve upstream of the inlet.
NOTE
Ensure that the filter will not overflow. Danger of emptying the pond.

It takes approx. 1 to 2 months before the micro-organisms in new filters are fully estab-
lished. During this time – or at a water temperature of <10 °C – biological cleaning may be
limited.
− When using filter starter, medicines or pond water treatments, leave the UVC clarifier
switched off for at least 36 hours so as not to impair their efficacy.
Prerequisite
• First switch on the pump, then the UVC clarifier.
• Check all connections for leaks.
Switching ON/switching OFF
• Switching on: Plug the power plug into the outlet.
– The unit switches on immediately.
• Switching off: Pull the power plug from the outlet.
EN
25