Installation, Connection And Setup; Pre-Assembling The Cable - Kathrein BZD 40 Betriebsanleitung

Installation, Connection and Setup

Pre-assembling the Cable

Cap
Figure 1
Braided shield
Figure 2
Bend back
braided shield
and aluminium
foil
Figure 3
Inner conductor
Figure 4
To fi t the F standard connector:
• Slot the cap onto the cable (see fi gure 1).
• Strip off the outer sheath of the cable, making sure you do not cut
through the braided shield (dimensions in mm) (see fi gure 2).
• Carefully bend back the braided shield (see fi gure 3).
• Expose the inner conductor as shown in fi gure 4 (dimensions in mm).
15