Changing The Floor-Tool Blades - Numatic TTB6055/100 Bedienungsanleitung

!
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF PRIOR TO ANY
The Floor Tool
To clean the floor-tool, remove securing-pin and pull-free from the holder (see Fig.33).
Rinse the floor-tool assembly with clean water and refit.
Periodically the floor-tool blades should be examined and checked for wear and damage.
The blade removal is easy. Simply start by removing the four retaining pins (see Fig.34), turn the
floor-tool over and separate the blade carrier from the body (see Fig.35).Peel away the blades from their locating
lugs (see Fig.36) and examine or renew as required.
Replacement is a reversal of the removal process.
Floor-tool overview
1. Floor-tool main body
2. Rear blade
3. Blade carrier
4. Front blade (slotted)
5. Retaining pins x 4

Changing the Floor-tool Blades

MAINTENANCE USING THE MASTER CONTROL ON/OFF KEY.
REMOVE THE KEY PRIOR TO ANY MAINTENANCE OPERATION.
Fig.33
Fig.35
1
2
3
4
48
Fig.36
5
!
Fig.34