Troubleshooting - Numatic TTB6055/100 Bedienungsanleitung

Trouble-Shooting
PROBLEM
Machine will not operate
Vacuum will not operate
Poor water pick-up
No brush / scrub function
Little or no water flow
Machine just 'stops' while
operating
Failure to rectify the problem or in the event of a breakdown
contact your Numatic dealer
or the Numatic Technical helpline +44 (0)1460 269268
(See back page for company addresses or dealers stamp)
CAUSE
Missing or blown fuses
Key in the 'Off' position
Low battery charge
Machine is connected and charging
Waste tank full switch stuck or clogged
Waste water tank full
Waste-water tank full
Clogged / blocked vacuum hose
Loose hose connections
Debris basket filter clogged / blocked
Separator filter clogged / blocked
Poor separator seal
Damaged separator seal
Damaged / split vacuum hose
Damaged floor-tool blades
Low battery charge
No brushes fitted
Brush deck raised
Clean-water tank empty
Clean-water tank filter blocked / clogged
Incorrect water flow setting
Brush deck raised
To much load on the brush system
12
SOLUTION
Fit or replace fuse (page 28)
Turn key to 'On' position (page 36)
Charge batteries (page 50)
Take off charge (page 52)
Inspect and clean switch (page40/46)
Empty waste water tank (page 40)
Empty waste-water tank (page 40)
Remove and clean (page 46)
Push tight connections (page 46)
Remove and clean (page 46)
Remove and clean (Page 46)
Clean and refit (page 46)
Renew (contact service dept)
Renew (contact service dept)
Renew (contact service dept)
Recharge batteries (page 50 - 52)
Check and fit (page 30)
Lower brush deck (page 36)
Fill clean-water tank (page 32)
Remove and clean (46)
Adjust as desired (Page 36)
Lower brush deck (page 36)
Reset the machine using the key and
decrease the brush load to best suit
the floor type (page 38)